3 January 2009, 1:05 pm
I'm doing a chemistry on propylene (propene) and when I Google propylene there's a lot more sites on polypropylene. I tried searching for a comparison of them but i couldn't find one. Are they similar enough that I can do the project by using both? Im supposed to find 5 to 10 common consumer materia... Read More »
1 January 2009, 9:26 pm
Description of Subs: * Paper/Polypropylene Cone * Single heat resistant voice coil * Rear-vented pole piece * Foam rubber surround * Large strontium ferrite magnet * Rubber magnet cover * Steel stamped frame * Suitable for sealed and vented installation * 600 watts maximum music power Description ... Read More »
1 January 2009, 5:45 am
Description of Subs: * Paper/Polypropylene Cone * Single heat resistant voice coil * Rear-vented pole piece * Foam rubber surround * Large strontium ferrite magnet * Rubber magnet cover * Steel stamped frame * Suitable for sealed and vented installa... Read More »
27 December 2008, 4:10 pm
I just bought new bottles, and they're of a different plastic than the ones I'm used to. Are they okay to boil? They seem like they'll rip if I do boil them... And do you know when it's okay to start using Level Two nipples? And where to buy the Y-cut nipples? It only says to boil the nipples.... Read More »
23 December 2008, 8:32 pm
Some forums say it would be in Divisoria but I don't exactly know where it would be in that place. Any help would be greatly appreciated. Thanks.... Read More »
22 December 2008, 7:00 pm
Road sign: http://www.treehugger.com/israel-road-sign.jpg (Most new road signs have no English.) Money: http://upload.wikimedia.org/wikipedia/commons/6/64/20_NIS_Bill_(polypropylene_and_paper)_Reverse.jpg If somebody wants to scan their Noblesse pack or some Yotvata for me that would be great. D... Read More »
20 December 2008, 5:47 pm
preferably an australian or online store... Read More »
15 December 2008, 10:06 pm
The cheap speakers. Like the ones you get in a stock car from the 1990's. Are the cones paper, plastic, some kind of composite, maybe even some kind of metal? I need a low-end comparison against the PEI materials, silks, fiberglass composites, and polypropylene materials. Thanks in advance.... Read More »
15 December 2008, 8:28 pm
I am going to be getting a kicker 12" sub with "12" subwoofer with dual 4-ohm voice coils injection-molded polypropylene cone ribbed Santoprene rubber surround suitable for marine use power handling: 50-400 watts RMS (200 watts per coil)" What kind of amp would be good for this sub? how do i kn... Read More »
14 December 2008, 3:57 pm
I'm putting together a few things incase I get stuck 4X4ing with my buddies. Would it be better to use chains or to buy a braided polypropylene rope to tow my 2003 TJ Jeep Wrangler? (its about 6250 pounds I believe).... Read More »
12 December 2008, 5:06 am
I have always used the traditional wire grids for my guinea pigs C&C cages. I saw these other cubes online yesterday. They seem like they would be just as good, if not better in that they'd allow less mess to slip outside of the cage. Here's a link if you want to look at them http://www.target.com... Read More »
Share on del.icio.us
Share on digg
Share on Technorati
Share on reddit
Share on Yahoo!
Share on Furl